SkyTrak 6036 Service Manual - Manual (Page 100)

Boom
3.60 Model 6036 Legacy
3.4.3 Quick Attach Removal
1. Remove the elastic locknut (Fig. 3-133, 1) and
capscrew (2) holding the attachment tilt cylinder rod
end pin (3) to the quick attach assembly (4). Save
the capscrew and discard the elastic locknut.
2. Support the rod end (Fig. 3-133, 5) of the
attachment tilt cylinder. Use a brass punch and
rawhide hammer to remove the pin (3) from the quick
attach assembly.
3. Inspect the pin (Fig. 3 -133, 3) for nicks or surface
corrosion. Use fine emery cloth to repair minor nicks
or corrosion. If damaged and cannot be repaired, the
pin must be replaced.
Figure 3-133 Remove Attachment Tilt
Cylinder Rod End Pin
4. Remove the elastic locknut (Fig. 3-134, 1) and
capscrew (2) holding the quick attach pivot pin (3) to
the quick attach assembly (4). Save the capscrew
and discard the elastic locknut. Place a support
under the quick attach assembly to prevent it from
dropping when the pivot pin is removed.
5. Use a brass punch and rawhide hammer to remove
the quick attach pivot pin (Fig. 3-134, 3) from the
quick attach assembly and the bushings in the
gooseneck. Record the location and quantity of the
shim washers (5 and 6) as the pin is being removed.
Save the washers (5 and 6) from each side of the
quick attach.
6. Inspect the pin (Fig. 3 -134, 3) for nicks or surface
corrosion. Use fine emery cloth to repair minor nicks
or corrosion. If damaged and cannot be repaired, the
pin must be replaced.
Figure 3- 134 Remove the Quick Attach Pivot Pin
3.4.4 Quick Attach Installation
1. Align the quick attach (Fig. 3-134, 4) between the
mounts on the gooseneck. Assemble a washer (6)
on each side of the quick attach. Reassemble the
shims (5) between the quick attach and the gooseneck.
DO NOT put all the shims on one side. The quick
attach should be centered in the gooseneck.
Note: ALWAYS replace elastic-lined nuts with new
elastic-lined nuts to help ensure proper fastening.
2. Coat the quick attach pivot pin (Fig. 3-134, 3) with
an anti-seize compound. Insert the quick attach pivot
pin through the gooseneck, washers, shims and
quick attach. Use a tapered punch to line up the hole
in the pivot pin with the hole in the quick attach.
Insert the 5/8-11 x 5" capscrew (2) through the quick
attach and pin. Secure the capscrew in place with a
new 5/8-11 elastic locknut (1). Tighten securely.
3. Coat the rod end pivot pin (Fig. 3-133, 3) with an
anti-seize compound. Swing the rod end (5) of the
attachment tilt cylinder up and align the rod end with
the mounting holes in the quick attach (4).
4. Insert the rod end pivot pin (Fig. 3 -133, 3) through
the aligned holes. Use a tapered punch to align the
capscrew hole in the pivot pin and the mounting hole
in the quick attach hub. Insert the 1/2-13 x 5"
capscrew (2) through the quick attach hub from the
backside and secure in place with a new 1/2-13
elastic locknut (1). Tighten securely.
MA6430
1
3
2
4
5
~
MA6440
5
4
3
2
1
5
6
6