SkyTrak 6036 Service Manual - Manual (Page 169)

6.7 Model 6036 Legacy
Transmission: ZF 4 WG-98 TC
9. Place a suitable receptacle under the transmission
drain plug (Fig. 6-6, 1). Remove the transmission
drain plug, and allow the transmission oil to drain
into the receptacle.
10. Transfer the used transmission oil into a suitable,
covered container, and label the container as “Used
Oil.” Dispose of used oil at an approved recycling
facility. Clean and reinstall the transmission drain
plug.
Figure 6-6 Drain Transmission Oil
11. Remove the engine-to-transmission drive shaft.
(Refer to Section 5.4.3, b. “Engine-to-Transmission
Drive Shaft.”)
12. Remove the transmission-to-axle drive shafts. (Refer
to Section 5.4.3, a. “Transmission-to-Axle Drive
Shafts.”)
13. Remove the hydraulic pump. (Refer to Section
8.11.2, a. “Pump Removal.”)
14. Label and disconnect the transmission temperature
switch connector (Fig. 6 -7, 1) and shift solenoid
wiring harness connectors (2 and 3).
15. Remove the capscrew (Fig. 6 -7, 4) securing the
black wire (5) to the transmission housing, and
disconnect the wire.
16. Remove the capscrew (Fig. 6 -7, 6) securing the
clamp (7) and wiring harness to the transmission
housing, and move the wiring harness safely out of
the way.
Figure 6- 7 Transmission Wiring
Harness Connector Location
OH2380
1
MA8960
1
2
3
7
6
4
5