SkyTrak 6036 Service Manual User Manual

Page 432

Advertising
background image

Electrical System

9.80

Model 6036 Legacy

Examine the fluid in the hydraulic oil sight glass
(Fig. 9 -63, 1) to check whether there is a sufficient
amount of fluid in the system (the oil level should be at the
bottom of the sight glass with all hydraulic cylinders
retracted) and whether the fluid is contaminated. Replace
the hydraulic oil filter as required. Explore other causes
for excessive temperature, such as high air temperature,
plugged oil cooler or lines, loose fan belt, plugged
radiator, etc. (Refer to Section 9.9.4, “Hydraulic Oil
Temperature Warning Indicator Troubleshooting.”)

Figure 9- 63 Examine the Fluid in the

Hydraulic Tank Oil Sight Glass

a. Hydraulic Tank Oil Temperature Switch Removal

1. Disconnect the negative (-) battery cable at the

negative battery terminal.

2. Drain oil from the hydraulic tank reservoir into a

clean container for reuse.

3. Label and disconnect the switch wiring connector

(Fig. 9-64, 3) from the harness connector.

4. Unthread the switch (Fig. 9 -64, 1) from the hydraulic

reservoir welded fitting (2).

b. Hydraulic Oil Temperature Switch Disassembly

DO NOT disassemble the hydraulic oil temperature
switch. Replace a defective or faulty switch with a new
switch.

c. Hydraulic Oil Temperature Switch Cleaning and

Drying

DO NOT submerge the hydraulic oil temperature switch.
Clean only with an approved solvent and dry with a clean,
lint-free cloth.

d. Hydraulic Oil Temperature Switch Inspection and

Replacement

Inspect switch wiring for continuity and shorting. Replace
a defective or faulty switch with a new switch.

e. Installation and Testing

1. Thread the switch (Fig. 9-64, 1) into its fitting (2) on

the hydraulic reservoir. Tighten securely.

2. Fill hydraulic oil reservoir with hydraulic oil.

Figure 9-64 Hydraulic Oil Temperature Switch

3. Connect the switch wiring connector lead (Fig. 9-64,

3) to the harness connector.

4. Connect the negative (-) battery cable to its battery

terminal.

5. Clear the area around the vehicle of personnel and

any obstructions to vehicle travel.

OH2340

1

MA7670

1

2

3

Advertising