SkyTrak 6036 Service Manual - Manual (Page 40)

General Information and Specifications
2.24 Model 6036 Legacy
2.12.7 After Tire and Wheel Service
1. Check air pressure.
2. Check wheel nut torque. Tighten to 450 lb/ft
(610 Nm).
2.12.8 After Engine Service
Consult the qualified service agent (manufacturer’s
representative and/or service manual) for proper
procedures before engine startup.
2.12.9 After Boom Service
1. Check wear pads.
2. Check chain tension adjustment.
3. Apply grease at all lubrication points (grease fittings).
(Refer to the appropriate Owners/Operators manual.)
4. Check for proper operation by operating all boom
functions through their full range of motion several
times.
2.12.10 After Axle Service
1. Check fluid levels.
2. Check torque on drive shaft flange yoke retaining
bolts. Tighten these M12 bolts to 156 lb/ft (212 Nm).
3. Check wheel nut torque. Tighten to 450 lb/ft (610 Nm).
4. Check toe-in if required.
5. Apply grease at all lubrication points (grease fittings).
6. Refer to the axle manufacturer’s maintenance
manual for further information.