SkyTrak 6036 Service Manual - Manual (Page 116)

Cab and Covers
4.12 Model 6036 Legacy
4.3.6 Joystick Assembly Replacement
Joystick Assembly Removal
1. Park the vehicle on a firm, level surface. Set the park
brake, ground the carriage, place the travel select
lever in the (N) NEUTRAL position, place the neutral
lock lever in the (N) NEUTRAL LOCK position,
engage the parking brake and turn the engine OFF.
2. Place an Accident Prevention Tag on both the
ignition key switch and steering wheel, stating that
the vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tag Usage.”)
3. Disconnect the battery negative (-) cable at the
battery negative (-) terminal.
4. Remove six hex-head capscrews, six lockwashers
and six flat washers (Fig. 4-18, 1) securing the upper
(2) and lower (3) transmission covers to the frame.
Remove the covers.
Figure 4-18 Remove the Upper and Lower
Transmission Covers
Note: Record the distance (Fig. 4 -19, 1) from the outer
jam nut to the end of the ferrule on all cables, to ensure
correct adjustment when reinstalling cables.
Note: Record the location, and label all cables to ensure
correct installation.
5. Disconnect the boom lift/lower control cable (Fig. 4-19,
2):
a. Remove the spring pin (Fig. 4-19, 3) and anchor
pin. Save the spring pin and anchor pin for
installation.
b. Loosen and remove the inner jam nut (Fig. 4-19, 4),
and remove the boom lift/lower control cable from
the bracket. Save the jam nut for installation.
c. Route the cable through the opening at the
bottom of the frame.
6. Repeat Step 5 to remove the boom extend/retract
control cable (Fig. 4-19, 5).
Figure 4-19 Disconnect the Lift/Lower and
Boom Extend/Retract Control Cables
Note: Record the distance (Fig. 4-20, 1) from the outer
jam nut to the end of the ferrule on all cables, to ensure
correct adjustment when reinstalling cables.
Note: Record the location, and label all cables to ensure
correct installation.
7. Disconnect the frame sway control cable (Fig. 4-20, 2):
a. Remove the spring pin (Fig. 4 -20, 3) and anchor
pin. Save the spring pin and anchor pin for
installation.
b. Loosen and remove the inner jam nut (Fig. 4-20, 4),
and remove the frame sway control cable from
the bracket. Save the jam nut for installation.
c. Route the cable through the opening at the
bottom of the frame.
8. Repeat Step 7 to remove the attachment tilt control
cable (Fig. 4 -20, 5).
MA8620
1
~
~
2
3
1
1
MA8480
3 4
2 5