SkyTrak 6036 Service Manual - Manual (Page 274)

Hydraulic System
8.58 Model 6036 Legacy
8.9 FOUR-WHEEL STEER INDEXING
PROCEDURE
If the vehicle does not drive “straight,” the steering could
be out-of-phase. Perform the following indexing
procedures to synchronize the front and rear steering.
1. With the steer select switch in the four-wheel steer
position, turn the steering wheel full left.
2. While holding the steering wheel full left, toggle the
steer select switch to the front-wheel steer position
and steer the front wheels back to center.
3. Toggle the steer select switch back to four-wheel
steer position and turn the steering wheel full left.
4. Toggle the steer select switch back to front-wheel
steer position and steer the front wheels full left.
5. Toggle the switch to the four-wheel steer position
and return to center.
The vehicle should now be properly indexed in four-wheel
steering. If the wheels are still out-of-phase, repeat the
above procedure. If, after repeating the above procedure,
the wheels are still out-of-phase, refer to Section 8.8.15,
“Four-Wheel Steering Circuit (Left Turn) and
Troubleshooting”, and Section 8.8.16, “Four-Wheel
Steering Circuit (Right Turn) and Troubleshooting.”