SkyTrak 6036 Service Manual - Manual (Page 213)

7.35 Model 6036 Legacy
Engine: Cummins 4BT3.9
35. Install the front (Fig. 7 -46, 9) and rear (10) band
clamps around the muffler (4), and install muffler.
Install the battery cable clamp (not shown) when
installing the muffler bracket (11) to the engine.
Figure 7-46 Exhaust System Installation
36. Install the tail pipe (Fig. 7-46, 7) to the muffler (4)
and install U-type clamp.
37. Install the exhaust pipe (Fig. 7-46, 2) to the muffler
(4).
38. Install the V-band clamp (Fig. 7-46, 1) to the exhaust
pipe (2).
39. Install the 2.75" U-type clamp (Fig. 7-46, 5) between
the muffler (4) and exhaust pipe (7).
40. Install the 2.75" U-type clamp (Fig. 7-46, 6) between
the tail pipe (7) and tail pipe support bracket (8).
Tighten all clamps.
41. Open the radiator cap (not shown) and fill the
radiator (Fig. 7-47, 1) completely with a 50/50
mixture of ethylene glycol and water. Replace and
tighten the radiator cap. Add coolant to the overflow
tank (2) until the bottle is 1/2 to 3/4 full. This
overfilling will compensate for any air trapped in the
cooling system.
Figure 7-47 Radiator Installation Procedure
42. Install the back-up alarm (Fig. 7 -48, 1) to the frame,
and connect engine harness connector (2) to
back-up alarm.
43. Install the battery (Fig. 7-48, 3), hold-down (4), two
hold-down washers (5) and nuts (6).
Figure 7-48 Battery Hold-down and
Back-up Alarm Location
44. Install the rear engine compartment door with the
help of at least one assistant. (Refer to Section
4.7.1, “Access Panel and Cover Replacement.”)
PH28302
1
2
3 4
5
6
8
9
10
7
Rear of Vehicle
11
OA1310
1
2
6
1
MA7970
4
3
2
5