SkyTrak 6036 Service Manual - Manual (Page 202)

Engine: Cummins 4BT3.9
7.24 Model 6036 Legacy
7.9.2 Exhaust System Installation
1. Install the muffler bracket (Fig. 7-26, 11) to the
engine, along with the battery cable clamp (not
shown).
Figure 7-26 Exhaust System Components
2. Install the tail pipe support bracket (Fig. 7-26, 8) to
the engine.
3. Install the front band clamp (Fig. 7-26, 9) and rear
band clamp (10) around the muffler (4), and install
muffler.
4. Install tail pipe (Fig. 7 -26, 7) to muffler (4) using a
2.75" U-type clamp (5).
5. Install the V-band clamp (Fig. 7 -26, 1) to the exhaust
pipe (2).
6. Install the 3" U-type clamp (Fig. 7-26, 3) between
the muffler (4) and exhaust pipe (2).
7. Connect the muffler to tail pipe connector (Fig. 7-26,
5).
8. Install the 2.75" U-type clamp (Fig. 7 -26, 6) between
the tail pipe (7) and tail pipe support bracket (8).
Tighten all clamps.
9. Connect the negative (-) battery cable (Fig. 7-2, 1).
10. Start engine, and check for exhaust leaks at all
exhaust connections. Adjust or repair as needed.
7.10 AIR CLEANER ASSEMBLY
If a replacement engine is being installed into the vehicle,
the air cleaner assembly must be transferred to the new
engine.
The air cleaner assembly should be transferred to the
replacement engine after the used engine is removed
from the vehicle.
IMPORTANT: Before transferring the air cleaner
assembly to the new engine, completely clean the
interior and exterior of the air cleaner assembly, and
replace the outer primary and inner safety elements.
Refer to the appropriate Owners/Operators manual for
your vehicle for the correct element change procedure.
Note: Always discard used elastic hex-head capscrews
and replace with new elastic hex-head capscrews.
7.10.1 Air Cleaner Assembly Removal
1. Remove the T-bolt band clamps (Fig. 7-27, 1 and 2)
securing the air intake hose (3) to the air cleaner
assembly (4) and engine intake. Remove the air
cleaner hose.
Figure 7-27 Air Cleaner Assembly
2. Remove the two hex-head capscrews (Fig. 7 -27, 5)
and lockwashers (6) securing the air cleaner
mounting bracket (7) to the engine (8). Remove the
bracket and attached air cleaner assembly (4).
PH28302
1
2
3 4
5
6
8
9
10
7
Rear of vehicle
11
CAUTION:
NEVER run the engine with
only the inner safety element installed.
MA9140
1
3
2
4
5
6
7
8