SkyTrak 6036 Service Manual User Manual
Page 132
Cab and Covers
4.28
Model 6036 Legacy
16. Remove one hex-lock elastic nut (Fig. 4-47, 1).
Disconnect the throttle cable rod end (2) at the
throttle lever extension bracket (3).
17. Remove two slotted pan-head screws (Fig. 4-47, 4)
two lockwashers, two hex nuts and clamp (5) from
the throttle cable bracket (6).
18. Cut the wire ties securing the throttle cable to the
hydraulic hoses on the right side of the frame, and
route the throttle cable (Fig. 4-47, 7) out of the
engine compartment and through the opening in the
bottom of the frame. Allow the cable to hang beneath
the cab.
Figure 4-47 Disconnect Throttle Cable
19. Attach a clevis (Fig. 4-48, 1 and 2) to each of the
cab lifting brackets. Route a sling (3) with a minimum
lifting capacity of 2,000 lbs. (907 kg.) through the
clevis’ to a hoist or overhead crane. Make sure the
sling is centered between the clevis’ to ensure even
lifting.
20. Remove the two upper cab-to-frame capscrews
(Fig. 4-48, 4) and two flat washers (5).
21. Remove the two lower cab-to-frame capscrews (Fig. 4-
48, 6) two flat washers (7).
Figure 4-48 Remove Cab Mounting Hardware
22. Remove the mirrors and all other cab components,
as needed, if not previously removed.
23. Carefully begin to lift the cab. Stop and check that all
wiring, hydraulic hoses and fasteners are
disconnected or removed. If the throttle cable is still
attached to the cab, reposition or remove the throttle
cable as necessary.
24. When all wiring, hydraulic hoses and fasteners are
disconnected or removed, carefully and slowly lift the
cab and remove it from the frame. Readjust the
position of the sling as needed to help balance the
cab during removal.
25. When the cab is completely clear of the vehicle,
carefully lower it to the ground. Block up or support
the cab so that it does not move or fall. Assure that
no personnel enter the cab while it is being removed
from the vehicle.
26. Inspect the condition of the fittings, clamps, hydraulic
hoses, etc. Replace parts as indicated by their
condition.
27. Inspect and replace other vehicle parts that are
exposed with the cab removed. Repair or replace as
required.
MA8610
3
5
1
4
2
~
7
4
~
6
MA8510
5
6
4
1
2
3
4
5
7
7 6
8