SkyTrak 6036 Service Manual - Manual (Page 443)

9.91 Model 6036 Legacy
Electrical System
9.15.8 Steer Select Switches
For additional information, refer to Section 9.7.9, “Front
Steer Circuit and Troubleshooting.”
a. Steer Select Switch Removal
1. Disconnect the negative (-) battery cable at the
negative battery terminal.
2. Carefully pry the switch (Fig. 9-82, 1) and wiring out
of the mounting hole in the switch bezel.
3. Label and disconnect the wiring from the switch.
Note and mark the “front” or top of the switch in
relation to the switch wiring terminals, and remove
the switch from the vehicle.
b. Steer Select Switch Disassembly, Inspection and
Replacement
DO NOT disassemble the switch. Replace a defective or
faulty switch with a new one.
Inspect the switch and the wiring harness connector
terminals for continuity and shorting in all three switch
positions. Inspect the switch terminals for continuity in the
“UP” and “DOWN” positions and for shorting in the
“MIDDLE” position. Replace a defective or faulty switch
with a new one.
c. Steer Select Switch Installation and Testing
1. Route the wiring through the dash and switch bezel,
then connect the wiring to the switch (Fig. 9 -82, 1)
as labeled during switch removal (the pin connector
only goes on one way).
2. Properly position the “front” and top of the switch as
noted during removal, then press or “snap” the
switch into place in the bezel.
Figure 9-83 Steer Select Switch Wiring
and Installation Position
3. Connect the negative (-) battery cable to its battery
terminal.
4. Clear the area around the vehicle of personnel and
any obstructions to vehicle travel.
5. Start the engine and check the operation of the steer
select switch functions with the switch in all three
positions. If the vehicle has the rear steer option,
also test the rear steer mode for proper operation.
Steering
Modes
Steering
Select
Switch
Display Panel Symbol
Steering Select Switch
Set for Front Wheel Steering;
see owners/operators manual
for explanation of operation/functions.
NOTE: Wire 11B, GRN is a
jumper wire.
9 GRY / BLK
11A GRN
2JJ BLK 8 GRN / WHT
11A GRN
MA8380
Top of Switch
1