SkyTrak 6036 Service Manual - Manual (Page 110)

Cab and Covers
4.6 Model 6036 Legacy
6. Working through the right dash panel opening,
disconnect the transmission travel and gear select
lever wiring connector (Fig. 4 -6, 1).
Figure 4-6 Disconnect the Transmission Travel and Gear
Select Lever Wiring Connector
7. Remove two hex socket-head screws (Fig. 4 -7, 1),
securing the transmission travel and gear select
lever (2) to the steering column.
8. Remove the transmission travel and gear select
lever (Fig. 4-7, 2) and collar (3).
Figure 4-7 Remove the Transmission
Travel and Gear Select Lever
d. Transmission Travel and Gear Select Lever
Installation
1. Position the transmission travel and gear select lever
(Fig. 4-7, 2) onto the steering column, aligning the
pin (4) with the hole (5) in the steering column.
2. Attach the transmission travel and gear select lever
with the collar (Fig. 4-7, 3) and two hex socket-head
screws (1). Tighten the screws and nuts securely, but
DO NOT overtighten. Overtightening will cause the
select lever to break.
3. Plug the wiring connector (Fig. 4 -6, 1) into the
harness connector.
4. Install the left dash panel (Fig. 4 -8, 1), and secure
with four button-head screws.
5. Install the right dash panel (Fig. 4-8, 2), and secure
with four button-head screws.
Figure 4- 8 Remove Dash Panels
6. Connect the battery negative (-) cable.
4.3.3 Steering Column/Valve Replacement
a. Steering Column and Valve Removal
1. Park the vehicle on a firm, level surface. Set the park
brake, ground the carriage, place the travel select
lever in the (N) NEUTRAL position, place the neutral
lock lever in the (N) NEUTRAL LOCK position,
engage the parking brake and turn the engine OFF.
2. Place an Accident Prevention Tag on both the
ignition key switch and steering wheel, stating that
the vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tag Usage.”)
MA8640
1
MA8650
3 4
2
1
5
MA8560
2
~
~
~
1
3
~