SkyTrak 6036 Service Manual - Manual (Page 78)

Boom
3.38 Model 6036 Legacy
Note: Steps 15-17 apply to vehicles not equipped with
auxiliary hydraulics. If the vehicle is equipped with
auxiliary hydraulics, proceed to Step 18.
15. Assemble the hoses to the hose reel at the rear of
the boom:
IMPORTANT: Keep the hoses in the same order as they
come from the hose clamps. DO NOT allow the hoses to
cross.
Note: Loosen the nuts and capscrews only enough to
pull the hoses around the hose reel.
a. Loosen, but DO NOT remove, the elastic
locknuts (Fig. 3-82, 1, 2 and 3) on the upper
retaining capscrew (4), lower retaining capscrew
(5) and center hose reel shoulder bolt (6).
b. Loosen, but DO NOT remove, the wear pad
mounting capscrews (Fig. 3-82, 7 and 8) securing
the hose reel assembly to the intermediate
boom.
c. Place the left side attachment tilt hose (Fig. 3-82,
9) into the second position from the left on the
hose reel.
d. Place the right side attachment tilt hose
(Fig. 3-82, 10) into the second position from the
right on the hose reel.
Figure 3-82 Assemble Hoses to Hose Reel Assembly
16. Tie the strings (positioned inside the outer boom
during the outer boom installation) to the male end of
each of the attachment tilt hoses coming off the
bottom hose reel assembly.
IMPORTANT: Keep the hoses in the same order as they
come off the hose reel. DO NOT allow the hoses to
cross.
17. Working from the front of the boom, pull each hose
through the boom assembly:
a. Pull the right side attachment tilt hose (Fig. 3-83, 1)
through the boom assembly. Pull the hose
through the opening (3) at the bottom of the outer
boom.
b. Pull the left attachment tilt hose (Fig. 3-83, 2)
through the boom assembly, keeping the left
attachment tilt hose to the left side of the hose
already down the boom. Pull the hose through
the opening (3) at the bottom of the outer boom.
c. Tighten the elastic locknuts (Fig. 3-82, 1, 2 and
3) on the hose reel assembly, and wear pad
mounting capscrews (Fig. 3-82, 7 and 8).
Proceed to Step 21.
Figure 3-83 Pull the Attachment Tilt Hoses Between the
Outer and Intermediate Boom Sections
MA8220
9
5
4
3
2
1
6
7
8
10
MH1700
2
1
1
2
3