SkyTrak 6036 Service Manual - Manual (Page 67)

3.27 Model 6036 Legacy
Boom
46. Position the right auxiliary hydraulic tube assembly
(Fig. 3-61, 1) into the inner hole in the mounting
plate (2). Secure the tube using the bulkhead nut (3).
47. Position the left auxiliary hydraulic tube assembly
(Fig. 3-61, 4) into the outer hole in the mounting
plate (2). Secure the tube using the bulkhead nut (3).
Note: ALWAYS use new o-rings when servicing the
vehicle.
48. Install new o-rings into the fittings. Lubricate o-rings
with clean hydraulic oil.
49. Connect the right auxiliary hydraulic hose (Fig. 3-61, 5)
to the tube at the mounting plate. Remove all twists
from the hose and tighten the hose connection.
50. Connect the left auxiliary hydraulic hose (Fig. 3-61, 6)
to the tube at the mounting plate. Remove all twists
from the hose and tighten the hose connection.
Figure 3-61 Install the Auxiliary Hydraulic
Tube Assemblies
51. Inside the rear of the outer boom, slide the threaded
clevis end (Fig. 3 -62, 1) of the retract chain down
the right side of the boom. Guide the threaded part
of the clevis out through the hole in the tab (2) on the
bottom of the outer boom. Pull the threaded part of
clevis all the way through the tab and coat the entire
threaded portion of the clevis with multi-purpose
grease.
52. Install one 3/4" flat washer (Fig. 3-62, 3) and a new
3/4-16 elastic locknut (4) onto the threaded clevis.
Thread the nut onto the clevis until the threads are
flush with the top of the nut.
Figure 3-62 Install the Retract Chain
MA7780
1
5
2
3
4
6
MH1460
1
2
3 4