SkyTrak 6036 Service Manual - Manual (Page 66)

Boom
3.26 Model 6036 Legacy
38. Install the attachment tilt tube assemblies (Fig. 3-59, 1)
to the bottom of the outer boom. Install the tube
clamp halves (2). Place one clamp half on each side
of the attachment tilt tubes. Secure each set of
clamp halves to the boom with a locking plate (3)
and a stacking bolt (4). Tighten the stacking bolt
securely to hold the upper tubes in place.
39. Place a lower clamp half (Fig. 3 -59, 5) on each side
of the auxiliary hydraulic tubes (6). Secure each set
of clamp halves to the stacking bolt with a clamp
cover (7) and one 5/16-18 x 1-1/4" capscrew (8), one
lockwasher (9) and one flat washer (10). Tighten the
capscrew securely to hold the lower tubes in place.
40. Repeat Steps 38 and 39 to assemble the clamps at
the other two clamp locations under the outer boom.
Figure 3-59 Install the Attachment Tilt and Auxiliary
Hydraulic Tubes on the Outer Boom
41. Position the attachment tilt retract tube assembly
(Fig. 3-60, 1) into the inner hole in the mounting
plate (2). Secure the tube using the bulkhead nut (3).
42. Position the attachment tilt extend tube assembly
(Fig. 3-60, 4) into the outer hole in the mounting
plate (2). Secure the tube using the bulkhead nut (3).
Note: ALWAYS use new o-rings when servicing the
vehicle.
43. Install new o-rings into the fittings. Lubricate o-rings
with clean hydraulic oil.
44. Connect the attachment tilt retract hose (Fig. 3-60, 5)
to the tube at the mounting plate. Remove all twists
from the hose, and tighten the hose connection.
45. Connect the attachment tilt extend hose (Fig. 3-60, 6)
to the tube at the mounting plate. Remove all twists
from the hose, and tighten the hose connection.
Figure 3- 60 Install the Attachment Tilt Tube Assemblies
MA6980
1
2
3
4
8
7
6
5
9
10
MA6860
1
5
2
3
4
6