SkyTrak 6036 Service Manual - Manual (Page 65)

3.25 Model 6036 Legacy
Boom
Figure 3- 56 Install the Extend and Retract Hoses
Note: Steps 32-37 apply to vehicles not equipped with
auxiliary hydraulics. If the vehicle is equipped with
auxiliary hydraulics, proceed to Step 38.
32. Install the attachment tilt tube assemblies (Fig. 3-57, 1)
to the bottom of the outer boom. Install the tube
clamp halves (2). Place one clamp half on each side
of the tubes. Secure each set of clamp halves to the
boom with a clamp cover (3), one flat washer (4), one
lockwasher (5) and one 5/16-18 x 1-1/4" capscrew
(6). Tighten the capscrew securely to hold the tubes
in place. Repeat for the other two clamp locations
under the outer boom.
Figure 3-57 Install the Attachment Tilt Tube Assemblies
33. Position the attachment tilt retract tube assembly
(Fig. 3 -58, 1) into the inner hole in the mounting
plate (2). Secure the tube using the bulkhead nut (3).
34. Position the attachment tilt extend tube assembly
(Fig. 3 -58, 4) into the outer hole in the mounting
plate (2). Secure the tube using the bulkhead nut (3).
Note: ALWAYS use new o-rings when servicing the
vehicle.
35. Install new o-rings into the fittings. Lubricate o-rings
with clean hydraulic oil.
36. Connect the attachment tilt retract hose (Fig. 3-58, 5)
to the tube at the mounting plate. Remove all twists
from the hose and tighten the hose connection.
37. Connect the attachment tilt extend hose (Fig. 3-58, 6)
to the tube at the mounting plate. Remove all twists
from the hose, and tighten the hose connection.
Proceed to Step 41.
Figure 3-58 Connect the Attachment Tilt Hoses
MA7920
1
2
3
4
5
MA6970
1
3
4
5
6
2
MA6720
1
3
2
4
5
6