SkyTrak 6036 Service Manual - Manual (Page 32)

General Information and Specifications
2.16 Model 6036 Legacy
2.5.12 Tamper Proofing
A tamper-proof means is in place on the following
adjustable components prior to machine shipment. This
can either be tamper-proof paint, or a steel tamper-proof
cap. DO NOT attempt to defeat, bypass or alter any
tamper-proof device.
• Main Valve Port Relief Valves (5) Standard, or (7)
Auxiliary Hydraulics
• Steering Relief Valve (1)
• Attachment Tilt Cylinder Counterbalance Valve (1)
• Lift/Lower Cylinder Counterbalance Valves (2)
• Extend/Retract Cylinder Counterbalance Valve (1)
• Main System Relief Valve (1)
• Parking Brake Relief (1)
2.5.13 Fork Ratings
All approved forks for this vehicle are marked with a
maximum load capacity rating. This rating (Fig. 2-3, 1) is
stamped on the left edge of the fork, just below the fork
pivot shaft. The rating is listed in U.S. pounds and based
upon a 24" (610 mm) load center (2).
This rating specifies the maximum load capacity that the
individual fork can safely carry at a maximum load center
of 24" (610 mm).
Since forks are always used in multiples, the total rating
of any combination of forks is the sum of their rated
capacities.
Other than block forks, use all forks in matched pairs. Use
block forks in matched sets.
Figure 2-3 Stamped Fork Rating Location
2.6 FLUIDS, LUBRICANTS AND
CAPACITIES
2.6.1 Axles (Differential Housings)
a. Axle Lubricants
In general, use a Universal Tractor Fluid that meets the
following specifications:
Nominal viscosity at 104° F (40° C) ...................... 55 cSt
Minimum viscosity at 212° F (100° C) .................. 9.1 cSt
Pour point (Maximum).............................. -32° F (-36° C)
Flash point (Minimum).............................392° F (200° C)
Minimum viscosity index ............................................135
Products known to meet these requirements include:
• JOHN DEERE: JDM J20C (HY-GARD)
• FORD/NEW HOLLAND: ESN-M2C134-D
(Hydraulic Oil 134)
• MASSEY-FERGUSON: M-1141
(PERMANTRAN III)
• CHEVRON: CHEVRON 1000 THF
b. Axle Capacities
Axles (differential housings) ...................9.5 qt (9.0 liters)
4000 x 24
4000 x 24
24 in.
(610mm)
OS03902
2
1