SkyTrak 6036 Service Manual - Manual (Page 74)

Boom
3.34 Model 6036 Legacy
3. Assemble the hose clamps to the floor of the inner
boom. Keep the two hoses on the left and right sides
as they come out of the rear of the inner boom:
a. Place a 5/16" lockwasher (Fig. 3-75, 1) and flat
washer (2) onto each 5/16-18 x 3-1/2" capscrew
(3), and insert the capscrews through the clamp
cover plate (4).
b. Place a hose clamp half (Fig. 3-75, 5) onto the
capscrews. Place the left attachment tilt hose (6)
and a hose clamp half (5) onto the capscrews.
Secure the capscrews to the floor of the inner
boom. Tighten the capscrews only enough to
hold the hoses in place.
c. Repeat Steps a and b to install the right attachment
tilt hose (Fig. 3-75, 7).
d. Position the attachment tilt hoses (Fig. 3-75, 6
and 7) with the edge of the tape (8) at the hose
clamps. Hold the attachment tilt hoses in this
position, and tighten the capscrews securely.
Proceed to Step 7.
Figure 3-75 Install the Attachment Tilt Hose Clamps
Inside the Inner Boom
4. Slide the female ends of the two attachment tilt
hoses (Fig. 3-76, 1 and 2) down the inner boom and
out to the gooseneck. Keep the hoses next to each
other as they are being pushed through the inner
boom.
At the opening in the gooseneck, pull both hoses
out. Be careful not to cross the hoses as you pull
them out. Label the left side hose (Fig. 3-76, 1) as
“Retract” and the right side hose (2) as “Extend.”
Label the hoses the same on the male ends.
5. Slide the female end of the two auxiliary hydraulics
hoses (Fig. 3-76, 3 and 4) through the inner boom
and out the gooseneck. Keep the auxiliary hoses to
the left and right sides of the attachment tilt hoses
(1 and 2).
At the opening in the gooseneck, pull both hoses out
and down toward the bulkhead plate for the couplers.
Keep the left side hose (Fig. 3 -76, 3) on the left side,
and label that hose as “Female Coupler.” Label both
ends of the hose. Keep the right side hose (4) on the
right side, and label that hose as “Male Nipple.”
Label both ends of the hose.
Figure 3-76 Install the Attachment Tilt and
Auxiliary Hydraulics Hoses
MA6950
5
4
2
3
1
6
7 8
MA6940
1
2
3
4