SkyTrak 6036 Service Manual - Manual (Page 33)

2.17 Model 6036 Legacy
General Information and Specifications
2.6.2 Axle Wheel Ends
a. Axle Wheel-End Lubricants
In general, use a Universal Tractor Fluid that meets the
following specifications:
Nominal viscosity at 104° F (40° C)....................... 55 cSt
Minimum viscosity at 212° F (10° C) .................... 9.1 cSt
Pour point (Maximum) .............................. -32° F (-36° C)
Flash point (Minimum) ............................ 392° F (200° C)
Minimum viscosity index............................................ 135
Products known to meet these requirements include:
• JOHN DEERE: JDM J20C (HY-GARD)
• FORD/NEW HOLLAND: ESN-M2C134-D
(Hydraulic Oil 134)
• MASSEY-FERGUSON: M-1141
(PERMANTRAN III)
• CHEVRON: CHEVRON 1000 THF
DO NOT add additional friction modifier to factory-filled
wheel ends. All wheel ends are factory-filled by the
manufacturer with oil. If a wheel end is drained for service, it
should be refilled with the gear oils listed.
Note: DO NOT use synthetic oil without the express
written consent of the manufacturer.
b. Axle Wheel-End Capacity
Wheel ends ......................................... 0.95 qt (0,9 liters)
2.6.3 Transmission
a. Transmission Fluid
In general, use a Universal Tractor Fluid that meets the
following specifications:
Nominal viscosity at 10° F (40° C)......................... 55 cSt
Minimum viscosity at 212° F (100° C) .................. 9.1 cSt
Pour point (Maximum) .............................. -32° F (-36° C)
Flash point (Minimum) ............................ 392° F (200° C)
Minimum viscosity index............................................ 135
Products known to meet these requirements include:
• JOHN DEERE: JDM J20C (HY-GARD)
• FORD/NEW HOLLAND: ESN-M2C134-D
(Hydraulic Oil 134)
• MASSEY-FERGUSON: M-1141
(PERMANTRAN III)
• CHEVRON: CHEVRON 1000 THF
b. Transmission Capacity
Capacity w/filter change .....................12.5 qt (11,8 liters)
Filter .......................................................1.5 qt (1,4 liters)
2.6.4 Lubrication Points (Grease Fittings)
Lubricants
When lubricating any component via the grease fittings,
use multi-purpose lithium-based grease with EP additives
that meets NLGI Grade 2 specifications. Products known
to meet these requirements include:
• AMOCO AMOLITH EP2
• ARCO LITHOLINE EP2
• BENZ MOLY-SERVICE EP2
• CHEVRON DUROLITH EP2
• CITGO H EP2
• GULF GULFCROWN EP2
• MOBILE MOBILUX EP2
• SHELL ALVANIA EP2
• SUN PRESTIGE 742EP
• TEXACO MULTIFAX EP2
Note: Refer to the appropriate Owners/Operators man-
ual for the maintenance schedule and checklist for
lubrication intervals and grease fitting locations.