SkyTrak 6036 Service Manual - Manual (Page 206)

Engine: Cummins 4BT3.9
7.28 Model 6036 Legacy
18. Remove the four hex-head capscrews (Fig. 7-35, 2)
and lockwashers (3) securing the flange yoke to the
engine.
19. Remove the drive shaft assembly (Fig. 7-35, 1) from
engine.
Figure 7- 35 Transmission-to-Engine Drive Shaft Removal
20. Disconnect the fuel inlet line (Fig. 7-36, 1) at the fuel
lift pump. Install a plug in the end of fuel inlet line.
Figure 7-36 Fuel Line Connections
21. Disconnect the fuel return line (Fig. 7 -36, 2) from the
injector pump (3).
22. Mark the location of the throttle cable (Fig. 7-36, 4)
at the throttle cable mount clamp (5). Remove clamp.
23. Disconnect the throttle cable (Fig. 7-36, 4) at the
engine throttle lever (6).
24. Remove the right side exhaust pipe mount bracket
(Fig. 7-37, 1) and hex-head capscrews (23) and
lockwashers (24) from the rear engine mount bracket
(2).
Note: Always discard used elastic locknuts and install
new elastic locknuts.
25. Remove the elastic locknut (Fig. 7 -37, 3), rebound
washer (4), engine isolator (5) and hex-head
capscrew (6) from the front right (7) and left (8)
engine mounting brackets.
26. Remove the hydraulic line clamps on both the right
and left sides of the engine.
27. Remove the four elastic locknuts (Fig. 7-37, 9), flat
washers (10) and two engine hold-down plates (11)
securing the lower rear engine mount bracket (12) to
the vehicle frame.
28. Position a fork truck behind the vehicle and drive
forward placing the forks underneath the upper rear
engine mount (Fig. 7-37, 2) and front right (7) and
left (8) engine mount brackets. Slightly lift the
engine, and back the engine out of the vehicle. Have
an assistant ensure that the engine clears all frame
components during removal.
MA8900
1
3
2
Engine
Transmission
MT2530
1
6
5
2
3
4