SkyTrak 6036 Service Manual - Manual (Page 46)

Boom
3.6 Model 6036 Legacy
13. If your vehicle is equipped with optional auxiliary
hydraulics, label and remove the two hoses (Fig. 3-6, 1)
from the bulkhead fittings (2) inside the gooseneck (3).
Plug the hose ends, and cap the bulkhead fittings to
prevent dirt and debris from entering the hydraulic
system.
If you are replacing the inner boom with a new inner
boom, remove the female coupler, male nipple and
bulkhead fittings from the bulkhead plate inside the
gooseneck.
Figure 3-6 Disconnect the Auxiliary Hydraulics Hoses
14. Without optional auxiliary hydraulics: Inside the
inner boom, remove the two capscrews (Fig. 3-7, 1),
two lockwashers (2) and two flat washers (3) holding
the clamp cover (4) and stack clamps (5) to the floor
of the inner boom. Remove the clamp cover plate
and all of the clamps. Proceed to Step 16.
Figure 3-7 Remove the Attachment Tilt Hose Clamps
from the Inner Boom
MA6410
2
1
2
3
MA6510
4
2
1
3
5