SkyTrak 6036 Service Manual - Manual (Page 210)

Engine: Cummins 4BT3.9
7.32 Model 6036 Legacy
13. Uncap the lines and install the transmission oil input
(Fig. 7-39, 1) and output (2) hoses to the radiator
fittings (3 and 4).
Figure 7-39 Transmission Oil Hose Connections
14. Secure the throttle cable (Fig. 7-40, 2) to the engine
throttle lever (7), located just above the starter.
15. Install the throttle cable mount clamp (Fig. 7 -40, 8)
over the throttle cable (1).
Figure 7-40 Throttle Cable Connection
16. Connect the fuel inlet line (Fig. 7-40, 3) to the fuel lift
pump (4).
17. Connect the fuel return line (Fig. 7-40, 5) to the fuel
injector pump (6).
18. Raise the drive shaft assembly (Fig. 7-41, 1) into
position. The slip-yoke end of the drive shaft mounts
toward the engine. If reinstalling a drive shaft
previously removed, align the flange yokes according to
the alignment marks made during removal.
IMPORTANT: Yokes at both ends of the drive shaft must
be in the same plane to help prevent excessive vibration.
Note: If installing a new drive shaft unit, special attention
need not be applied to installation. New drive shaft units
are balanced at the factory.
19. At the drive shaft (Fig. 7-41, 1), install the four hex-
head capscrews (2), and four lockwashers (3) securing
the flange yoke (4) to the engine. Torque to 105 ±10
lb/ft (142 ±14 Nm).
Figure 7-41 Drive Shaft Installation
20. Install the fuel sender with new gasket (Fig. 7-42, 6)
to the fuel tank.
21. Attach fuel sender harness connectors (Fig. 7-42, 1)
to the sender unit and secure with #10 x 5/8" screws
(5). DO NOT overtighten.
1
2
3
MA9130
4
MT2530
1
2
3
4
5
6
7
8
MA8900
1
3
2
To Transmission
To Engine
4