SkyTrak 6036 Service Manual - Manual (Page 51)

3.11 Model 6036 Legacy
Boom
6. Remove the capscrews (Fig. 3-19, 1), lockwashers
(2) and flat washers (3) holding the hose reel side
plate (4), lower left side wear pad (5) and shims (6)
to the side of the intermediate boom. Save the
capscrews, lockwashers, flat washers, shims and
wear pad inserts (7).
Figure 3-19 Remove the Intermediate Boom
Hose Reel Side Plate
7. Remove the hose reel assembly, with hoses, from
the rear of the boom. Allow the hose reel assembly
to slide down the hoses, out of the boom and allow it
to rest on the floor.
8. Label and remove the hoses from the hose reel
assembly. The center bolt (Fig. 3-20, 1) can remain
in place to hold the hose reel and side plates
together.
a. Remove the 3/8-16 elastic locknut (Fig. 3-20, 2)
and 3/8" flat washer (3) from the lower retaining
shoulder bolt (4). While pulling the shoulder bolt
out, catch the spacers (5) from between the
plates as the bolt is removed. Pull the bolt out far
enough to remove the hoses from the hose reel.
b. After the hoses are removed from behind the
lower retaining bolt (Fig. 3-20, 4), insert the
shoulder bolt through the plates, inserting the
spacers between the plates as the bolt is
inserted. Loosely reassemble the 3/8" flat
washer (3) and 3/8-16 elastic locknut (2) to hold
the shoulder bolt in place. DO NOT fully tighten
at this time.
c. Remove the 1/2-13 elastic locknut (Fig. 3 -20, 6)
from the upper retaining capscrew (7). While
pulling the capscrew out, catch the spacers (8)
from between the plates as the capscrew is
removed. Pull the capscrew out far enough to
remove the hoses from the hose reel.
d. After the hoses are removed, insert the capscrew
(Fig. 3-20, 7) through the plates, inserting the
spacers (8) between the plates as the capscrew
is inserted. Reassemble the 1/2-13 elastic
locknut (6) to hold the capscrew in place.
Figure 3-20 Remove the Hoses from the
Hose Reel Assembly
MA6640
5
4
3
2
6
7
1
MA6560
1
2
8
3
4
5
6
7