SkyTrak 6036 Service Manual - Manual (Page 50)

Boom
3.10 Model 6036 Legacy
3. At the front of the outer boom (Fig. 3 -16, 1), remove
the capscrews (2), lockwashers (3) and flat washers
(4) holding the side wear pads (5) and shims (6) to
the inside of the outer boom. Label the wear pads as
“Left Top/Bottom” and “Right Top/Bottom.” Save the
capscrews, lockwashers, flat washers, shims and
wear pad inserts (7).
Figure 3-16 Remove the Outer Boom Left and
Right Side Wear Pads
4. If replacing the intermediate boom with a new boom
section, remove the lower wear pads at the front of
the boom. Remove two 3/8-16 x 1-3/4" capscrews
(Fig. 3-17, 1) and one 3/8-16 x 1" capscrew (2),
three lockwashers (3) and three flat washers (4)
securing each lower wear pad (5) and spacers (6) to
the inside of the boom. Label the wear pads and
spacers as “Left” or “Right” sides. Save the capscrews,
lockwashers, spacers and wear pad inserts (7).
Figure 3-17 Remove the Intermediate Boom Lower,
Front Wear Pads
5. At the rear of the boom, remove two capscrews
(Fig. 3-18, 1), two lockwashers (2) and two flat washers
(3) holding the hose reel assembly (4), lower wear pad
(5) and spacer (6) to the lower plate on the intermediate
boom. Reassemble the capscrews, lockwashers and
flat washers to hold the lower wear pad in place for
intermediate boom removal.
Figure 3-18 Remove the Hose Reel Assembly from the
Rear of the Intermediate Boom
MA7400
7
5
4
3
6
2
1
MA7410
4
3
2 1
5
6
7
3
4
4
3
1
MA6630
1
2
3
4
5
6