SkyTrak 6036 Service Manual - Manual (Page 350)

Hydraulic System
8.134 Model 6036 Legacy
Figure 8-90 Side Tilt Carriage (Optional)
f. Side Tilt Carriage Cylinder Installation
1. Install the side tilt carriage cylinder (Fig. 8-90, 2)
onto the side tilt carriage (1). Secure the rod end to
the side tilt carriage with the cylinder rod pin (6) and
snap rings (4). Secure the tube end to the pivot base
(7) with the cylinder base pin (5) and snap rings (4).
2. Lubricate the pivot pins (5 and 6) with multi-purpose
grease.
3. Remove all plugs and caps from the hydraulic lines
and securely tighten the lines to the cylinder.
4. Start the engine and remove any blocking from the
carriage.
5. Tilt the side carriage five times through its full range
or until operation of the side tilt carriage is normal
(no jerks or spongy feel).
6. Shut the engine OFF. Check the hydraulic level and
fill as required.
MT1950
1
2
4
6
4
3
5
4
7
WARNING:
Escaping hydraulic fluid
under pressure can penetrate the skin, causing
death or serious injury.
WARNING:
Avoid prolonged engine
operation in closed areas with inadequate
ventilation. Failure to properly ventilate exhaust
fumes can result in death or serious injury.