SkyTrak 6036 Service Manual - Manual (Page 442)

Electrical System
9.90 Model 6036 Legacy
Crab-Steer Mode
With the steer select switch in the uppermost
position (Fig. 9-82, 4), the following conditions
must be met:
1. Front wheels (Fig. 9-81, 1) must steer in the
direction that the steering wheel is turned.
Figure 9-81 Crab Steer
2. Rear wheels (Fig. 9-81, 2) must steer in the
direction that the steering wheel is turned. (Refer to
Section 9.7.11, “Crab Steer Circuit and
Troubleshooting.”)
c. Four-Wheel Steer Indexing
If the vehicle does not drive “straight,” the steering may
not be synchronized or “out of phase.” Perform the four-
wheel steer indexing procedure to synchronize the
steering.
1. With the steer select switch (Fig. 9-82, 1) in the four-
wheel steer position (2), turn the steering wheel fully
left.
Figure 9-82 Steer Select Switch Positions
2. While holding the steering wheel fully left, toggle the
steer select switch to the front-wheel steer position
(Fig. 9-82, 3).
3. Steer the front wheels back to center.
4. Toggle the steer select switch back to four-wheel
steer position (Fig. 9 -82, 2).
5. Turn the steering wheel fully left.
6. Toggle the steer select switch back to the front-wheel
steer position (Fig. 9 -82, 3).
7. Steer the front wheels fully left.
8. Toggle the switch to the four-wheel steer position
(Fig. 9-82, 2) and return to center.
The vehicle should now be properly indexed in four-wheel
steer. If the steering is still not synchronized, repeat the
procedure. (Refer to Section 9.7.9, “Front Steer Circuit
and Troubleshooting” and subsequent circuits and
troubleshooting charts.)
OH2591
OH1680
1
2
OH19412
2
1
3
4