SkyTrak 6036 Service Manual - Manual (Page 146)

Axles, Drive Shafts, Wheels and Tires
5.10 Model 6036 Legacy
Note: ALWAYS use new o-rings when servicing the
vehicle.
13. Install new o-rings into the fittings. Lubricate the
o-rings with clean hydraulic oil.
14. Uncap and connect the steering and brake lines at
their axle fittings.
15. Check wheel end and hydraulic reservoir oil levels.
16. Start the engine. Turn the steering wheel several
times lock to lock, operate the frame tilt function
several times in both directions and check the
function of the brakes. Check for hydraulic leaks, and
tighten or repair as necessary.
17. Front Axle Only: Install the front access panel
(Fig. 5-7, 1) and secure with four button-head
screws (2)
Figure 5-7 Install Front Access Panel
WARNING:
Avoid prolonged engine
operation in closed areas without adequate
ventilation. Failure to properly ventilate
exhaust fumes can result in death or severe
personal injury.
WARNING:
Escaping hydraulic fluid
under pressure can penetrate the skin, causing
death or serious injury. Before starting the
engine, tighten all hydraulic connections and
remove all tools from the vehicle. NEVER
check for leaks using any part of the human
body; use a piece of cardboard or wood
instead. Wear heavy, protective gloves and
eye protection.
MA9090
2
1
~
2