SkyTrak 6036 Service Manual - Manual (Page 383)

9.31 Model 6036 Legacy
Electrical System
If OK
Not
OK
Check for battery voltage at
circuit 8 (LT GRN/WHT)
at steer select valve. Check
2C (BLK) ground connection.
With steer select switch
in crab steer mode,
only 2-wheel steering
is active.
Check circuit 8 (LT GRN/
WHT) from steer select
solenoid to steer select
switch. Check for open or
short to ground.
Check resistance on steer
select valve solenoid for
5 to 7 ohms.
If OK
Check 10-amp steer
select mode fuse.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. All connections relating
to circuit are clean and
tight.
Replace steer select
valve solenoid.
See Section 8.8, “Hydraulic
Circuits and Troubleshooting”
for additional information.
If OK
Not
OK