SkyTrak 6036 Service Manual User Manual
Page 422
Electrical System
9.70
Model 6036 Legacy
9.13
WINDOW WIPER/WASHER (OPTION)
9.13.1
Windshield Wiper Switch
Figure 9-47 Windshield Wiper Switch Location
The windshield wiper switch (Fig. 9-47, 1) is
supplied on enclosed cab models only. The
front windshield wiper is located on the dash
panel to the right of the steering column and is
pressed or “snapped” into a rectangular switch bezel. It is
a three-position switch providing OFF (upper position),
center for LOW speed and lower position for HIGH speed
operation.
a. Removal
1. Disconnect the negative (-) battery cable at the
negative battery terminal.
2. Carefully pry the windshield wiper switch (Fig. 9-47,
1) and wire connector out of the mounting hole.
3. Disconnect the windshield wiper switch with bezel
from the cab wiring harness connector.
b. Disassembly
DO NOT disassemble the switch. The switch is not
serviceable. Replace the switch if found to be defective.
c. Cleaning and Drying
Without submerging the switch, clean the switch with an
approved solvent and dry with a clean, lint-free cloth.
d. Inspection and Replacement
1. Inspect the switch terminals for continuity with the
switch in the OFF, LOW speed and HIGH speed
positions. (Refer to Section 9.7.12, “Front
Windshield Wiper Circuit and Troubleshooting
(Option).”)
2. Replace the switch if it fails any of the tests in Step
1
.
e. Installation and Testing
1. Connect the windshield wiper switch to the cab
harness connector.
2. Position the switch over the rectangular switch bezel,
and snap into position.
3. Connect negative (-) battery cable at the negative
battery terminal.
4. Turn the ignition key switch to the RUN position and
test the windshield wiper LOW speed and HIGH
speed functions.
9.13.2
Windshield Wiper Motor
Figure 9- 48 Windshield Wiper Motor Location
a. Removal
Note: It may be necessary to remove several hydraulic
hoses from under the dash in order to remove and install
the wiper motor housing. (Refer to Section 4.3.3, “Steer-
ing Column/Valve Replacement.”)
1. Disconnect the negative (-) battery cable at the
negative battery terminal.
2. Remove the right side instrument panel.
3. Remove the lower access panel below the
instrument panel.
4. Disconnect the right side defroster hose from dash
panel hose connector.
5. Disconnect the cab harness connectors from the
wiper motor (Fig. 9-48, 1).
1
OH18502
OS19302
1
MA8430
1
5
4
3
2
8
7
6
10
9
11
12
13