SkyTrak 6036 Service Manual - Manual (Page 120)

Cab and Covers
4.16 Model 6036 Legacy
8. Remove three hex-head capscrews (Fig. 4-27, 1)
three lockwashers and three flat washers.
9. Remove the auxiliary hydraulics joystick assembly
(Fig. 4-27, 2) from the vehicle.
Figure 4-27 Remove the Auxiliary Hydraulics
Joystick Assembly
b. Auxiliary Hydraulics Joystick Installation
1. Route the control cable through the opening at the
bottom of the cab.
2. Secure the auxiliary hydraulics joystick assembly
(Fig. 4-27, 2) to the cab console with three hex-head
capscrews (1) three lockwashers and three flat
washers.
3. Connect the auxiliary hydraulics control cable to the
main control valve:
a. Slide the inner jam nut (Fig. 4-28, 1) over the
end of the auxiliary hydraulics control cable (2),
and install the cable in the bracket with one nut
on either side of the bracket. DO NOT tighten the
jam nuts at this time.
b. Connect the end of the cable to the shaft from
the control valve. Secure with an anchor pin and
spring pin (Fig. 4-28, 3).
c. Adjust the jam nuts until the distance (Fig. 4-28, 4)
from the outer jam nut to the end of the ferrule is
the same as recorded during removal. Tighten
the jam nuts.
Figure 4-28 Connect the Auxiliary Hydraulics Control
Cable to the Main Control Valve
4. Install the joystick access panel (Fig. 4-29, 1) and
secure using four button-head screws (2).
Figure 4-29 Install the Joystick Access Panel
MA8530
2
1
4
MA8490 2
3
1
OH2430
2
1
~
2