SkyTrak 6036 Service Manual - Manual (Page 212)

Engine: Cummins 4BT3.9
7.34 Model 6036 Legacy
29. Connect the engine coolant temperature switch lead
(Fig. 7-43, 1) and oil pressure switch lead (2). (Refer
to Section 9.15.11, “Engine Coolant High
Temperature Sender,” and Section 9.15.10, “Engine
Low Oil Pressure Sender.”)
30. Connect the fuel shut-off solenoid harness
connector (Fig. 7 -43, 3) to the fuel shut-off solenoid.
Figure 7-43 Connect the Engine Coolant
Temperature Switch Lead and Oil Pressure Switch Lead
31. Connect the alternator ground wire (Fig. 7-44, 1),
D+ (2) and B+ (3) harness wire leads.
Figure 7-44 Connect the Tagged Alternator Wires
32. Position the starter (Fig. 7-45, 1) in its mounting
opening on the flywheel housing. Position the
ground cable (2) over the lower starter bolt. Secure
the starter with three 12-point fasteners (3). Torque
fasteners to 32 lb/ft (43 Nm).
33. Install the red, positive (+) battery cable (Fig. 7-45,
4) and two red wires (5) to the upper solenoid stud
(6). Install a lockwasher and nut on stud, and finger
tighten. DO NOT connect the negative (-) lead at this
time.
34. Install the blue/orange wire (Fig. 7-45, 7) to the
solenoid mounting stud (8). Install a lockwasher and
nut to the stud. Torque to 3.4 lb/ft (4,6 Nm).
Figure 7-45 Install Starter and Connect
Wires to the Starter
MA9070
2
1
3
B+
D+
D-
ORG
BLK
YEL
2W
G
6
38
5
RED
MA8400
3 1
2
MA8420
1
3
2
4
6
5
8
7