SkyTrak 6036 Service Manual - Manual (Page 130)

Cab and Covers
4.26 Model 6036 Legacy
7. Working under the cab, loosen the clamp screw
(Fig. 4-41, 1) and disconnect the heater control
cable (2) from the heater control valve (3).
Note: Label all hoses to ensure correct installation.
8. Loosen the hose clamps (Fig. 4 -41, 4 and 5), and
disconnect the heater hoses (6 and 7).
Figure 4-41 Disconnect Heater Hoses
9. Remove four button-head screws (Fig. 4-42, 1) and
remove the console panel (2).
Figure 4-42 Remove the Console Panel
10. Disconnect the two cab-to-wiring harness
connectors (Fig. 4 -43, 1 and 2). Push the harness
connectors through the opening (3) at the bottom of
the cab.
Figure 4-43 Disconnect the Wiring Connectors
Note: Record the location, and label all cables to ensure
correct installation.
11. Disconnect control cables at the joystick:
a. Push the control lever to expose the flats (Fig. 4-
44, 1) on the slider head. Place a 3/4" wrench on
the flats to hold the slider head, and loosen the
cable nut (2).
b. Loosen the upper jam nut (Fig. 4-44, 3), and
remove the boom extend/retract cable (4) from
the bracket.
c. Push the cable through the opening at the
bottom of the cab.
d. Repeat Steps a-c to disconnect the boom lift/
lower (Fig. 4-44, 5), attachment tilt (6) and frame
sway (7) control cables.
MA8780
1
4
2
3
6
5 7
OH2430
1
2
~
1
MA8470
2
3
1