Metrohm viva 1.0 Manual - Manual (Page 281)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
viva 1.0
￭￭￭￭￭￭￭￭ 269
Jump to the next determination.
Jump to the last determination.
4.5.2.5.5.2 Result view - Curves
The curves of the selected determination are displayed on the Curves tab.
A tab with the corresponding command name is present for each run of a
measuring command; their sequence is determined by the method.
4.5.2.5.5.2.1 Curve display CVS
Tabs
In the curve window, a tab with the corresponding command name is
provided for each run of a VA measuring command; their sequence is
determined by the method. The upper part of these tabs shows the
recorded voltammograms or calibration curves and the lower part con-
tains information on the individual measuring curves. The
symbols
serve to maximize either the upper or the lower part to the size of the
entire curve window or reset it again.
An icon representing the type of displayed curves is located next to the
title of the tab. You can toggle between the types by clicking on this icon.
Shows the voltammograms (see Chapter 4.6.1.2.1, page 304).
Shows the calibration curve (see Chapter 4.6.1.2.2, page 306).
4.5.2.5.5.2.1.1 Voltammograms
Tab: Database ▶ Determination overview ▶ Determinations ▶ Repro-
cess... ▶ Reprocess ▶ Result view ▶ Curves
Voltammogram display
The following elements are displayed in the upper part of the curve win-
dow:
￭ Axes with labeling (measured quantity and unit)
￭ Measuring point curves
￭ Peak label with substance name
￭ Baselines
￭ Base points
Zoom
Curves can be zoomed as often as required by spanning an area of the
curve display from the top left to the bottom right with the left mouse
button pressed down. Zooming can be undone by spanning an area from