Metrohm viva 1.0 Manual - Manual (Page 454)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
442 ￭￭￭￭￭￭￭￭
viva 1.0
[New]
Opens the External measured value # dialog window, in which the
parameters for the external measured value can be entered (see Chapter
5.5.2.5.7.2, page 458).
[Properties]
Opens the External measured value # dialog window, in which the
parameters for the external measured value can be edited (see Chapter
5.5.2.5.7.2, page 458).
[Delete]
Deletes the external measured value selected in the table.
5.5.2.5.4.6 MEAS Opt - Fixed endpoint evaluation
Dialog window: Method ▶ MEAS Opt ▶ Properties... ▶ Evaluations ▶ Fixed end-
point evaluation #
Measured quantity
Selection of the fixed measured quantity to which the associated values
for the other quantities are to be interpolated from the list of measured
points.
Selection Measured value | Time
Default value Measured value
Fixed value
Value of the fixed endpoint.
Measured value
Input range
0 - 4,000 mAU
Time
Input range
0.0 - 999,999.9 s
5.5.2.5.5 MEAS Opt Conc
5.5.2.5.5.1 MEAS Opt Conc - Overview
Dialog window: Method ▶ MEAS Opt Conc ▶ Properties... ▶ MEAS Opt Conc -
'Command name'
Command for concentration measurements (direct measurement)
with spectrometer or photometer.
Instruments
This command can be executed with the following instruments:
Spectrometer: Avantes
Photometer: 089