Metrohm viva 1.0 Manual - Manual (Page 493)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 481
￭ ADD SAMPLE - Properties
Command variables
The following command variables are generated by the ADD SAMPLE
command in the method run and can be used in formulas under the des-
ignation 'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
CYL Cylinder volume of the dosing unit used for the com-
mand
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
VOL Currently dosed volume in L (Number)
5.5.2.7.4.2 ADD SAMPLE - Properties
Dialog window: Method ▶ ADD SAMPLE ▶ Properties... ▶ ADD SAMPLE - 'Com-
mand name'
Command name
Name of the command.
Entry 25 characters
Addition
Selection of the addition mode for the sample.
Selection Add manually | Already added | Add with dos-
ing device
Default value Add manually
Add manually
Manual addition of the sample, at which time the track is stopped. A
message appears and an acoustic signal is heard.
Already added
The sample is located already in the measuring vessel or was channeled
into the measuring vessel, e.g. with a peristaltic pump. The track is not
stopped. No message appears and no acoustic signal is heard.