2 call - properties – Metrohm viva 1.0 Manual User Manual
Page 423
■■■■■■■■■■■■■■■■■■■■■■
5 Method
viva 1.0
■■■■■■■■
411
A maximum of 10 calls per command are possible.
Parameters
The parameters for the CALL command are configured in the following
dialog window:
■
Command variables
The following command variables are generated by the CALL command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identification
Description
BSY
Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN
Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
5.5.2.4.2.2
CALL - Properties
Dialog window: Method
▶ CALL ▶ Properties... ▶ CALL - Call #
Command name
Name of the command.
Entry
25 characters
Call table
All of the defined calls that are listed in the table are executed simultane-
ously. The table cannot be edited directly.