Metrohm viva 1.0 Manual - Manual (Page 833)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
9 Support
viva 1.0
￭￭￭￭￭￭￭￭ 821
3 Select the desired Method group.
4 Select the desired methods.
5 Click on the Edit ▶ Export... menu item.
The Select directory for export dialog window opens.
6 Select the desired directory for the export files and click on [OK].
The selected methods are each exported to a file named 'Method
name'.vmet.
NOTE
The exported methods are stored uncoded but with a checksum. If
a file stored in this manner is tampered with, then it cannot be
imported again.
9.1.2 Determinations
9.1.2.1 Starting a single determination
How to proceed?
1 Select the Workplace program part.
2 Select the Single determination tab in the Run subwindow.
3 If desired, enter Determination parameters.
4 In the Method selection list, select the method to be used for carry-
ing out the determination.
The Method subwindow shows the loaded method.
5 Enter Sample data.
6 Click on [Start].
The single determination will be started. Active tracks and commands
are displayed in the Method subwindow; live curves, measured val-
ues and messages in the Live display subwindow; and measure-
ment and calibration curves in the Curves subwindow.