Metrohm viva 1.0 Manual - Manual (Page 784)

7.6 Avantes Spectrometer
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
772 ￭￭￭￭￭￭￭￭
viva 1.0
Analog output
Analog output
on | off (Default value: on)
If this check box is activated, then the measuring signal is output at the
analog output of the spectrometer. If the connected spectrometer is not
equipped with an analog output, then this setting will be ignored.
Sensitivity
Input range 1 - 214,783,647 mAU/mV
Default value 100 mAU/mV
7.6.4 Properties - Detector
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Detector
The Detector tab shows information on the detector that is built into the
spectrometer.
Detector type
Shows the detector type.
Minimum wavelength
Shows the minimum wavelength of the measurable range in nm.
Maximum wavelength
Shows the maximum wavelength of the measurable range in nm.
Number of pixels
Shows the resolution with which the spectrum is recorded.
7.6.5 Properties - Calibration
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Calibration
The Calibration tab shows the data of the wavelength calibration. A
wavelength defined by four wavelength coefficients is allocated to each
pixel on the detector. This wavelength calibration is carried out with the
CAL Spec command. In this process, the calibration data is calculated
automatically and displayed on this tab.
Date
Shows the time and date of the wavelength calibration.