Metrohm viva 1.0 Manual - Manual (Page 410)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
398 ￭￭￭￭￭￭￭￭
viva 1.0
12 Sweep
The sweep is executed in accordance with the defined sweep param-
eters.
13 Cleaning potential
Cleaning potential is applied to the electrodes.
14 Cleaning time
Idle until the period defined in the Cleaning time parameter has
expired.
only for hydrody-
namic measurement
= on
15 Stirrer off
The stirrer is switched off.
only for standby
potential = off
16 Potential off
The potential applied to the electrodes is switched off.
only for standby
potential
≠
off
17 Standby potential on
Standby potential is applied to the electrodes.
Parameters
The parameters for the CVS command are set on the following tabs:
￭ General/Hardware (see Chapter 5.5.2.3.2.2, page 403)
￭ Pre-treatment (see Chapter 5.5.2.3.2.3, page 405)
￭ Sweep (see Chapter 5.5.2.3.2.4, page 406)
￭ Post-treatment (see Chapter 5.5.2.3.2.5, page 408)
￭ Potentiostat (see Chapter 5.5.2.3.2.6, page 409)
Command variables
The following command variables are generated by the CVS command in
the method run and can be used in formulas under the designation 'Com-
mand name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
DBL Total duration for the processing of the command in
s