Metrohm viva 1.0 Manual - Manual (Page 464)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
452 ￭￭￭￭￭￭￭￭
viva 1.0
￭ General/Hardware
Parameters for instrument.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated by the MEAS TMF com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identifica-
tion Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
DBL Total duration for the processing of the command in s
EME End measured value (measured value after processing of
the command) in the unit of the measured value
ETE End temperature (temperature following processing of
the command) in °C
FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
ITE Initial temperature (temperature before start conditions
are processed) in °C
LP.MEA Measured value for the last measuring point of the mea-
suring point list in the unit of the measured value
LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
LP.TIM Time in s until the last measuring point in the measuring
point list is reached
MTE Temperature measurement with sensor; 1 = on, 0 =
off)
NMP Number of measuring points in measuring point list
STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
TMF Transmission factor