Metrohm viva 1.0 Manual - Manual (Page 293)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
viva 1.0
￭￭￭￭￭￭￭￭ 281
Selection red | 13 colors
Default value red
Line thickness
Line thickness of baselines.
Input range 1 - 10 pixels
Default value 1 pixels
Curve properties CVS - y2 axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ y2 Axis
Parameters for the graphical display of the overlaid curves on the y2 axis
(right-hand y axis).
Quantity
Selection of the quantity to be shown on the y2 axis.
Selection Current [A] | Voltage [V] | Time [s] | Current
measuring range [A] | off
Default value off
Label
Freely definable axis label for the y2 axis. If auto is selected, then the des-
ignation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Numerical format
Selection of the numerical format for the labeling of the y2 axis.
Selection decimal | scientific | engineering
Default value engineering
decimal
The axis is labeled in the decimal format ±##.### (floating-point num-
ber).
scientific
The axis is labeled in the scientific format ±#.###e±###.
engineering
The axis is labeled in the technical format ±###.###+prefix (engi-
neering format). The prefix (m, µ, n, p) is added to the figure.