Metrohm viva 1.0 Manual - Manual (Page 38)

2.3 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
26 ￭￭￭￭￭￭￭￭
viva 1.0
Designation Description Commands
LPO Current absolute lift position in mm (entry when ending the command) LIFT
LST Start time of the loop command (Date/Time) CALL COND
CAL LOOP
Opt, LOOP
MA.CNT Intensity for maximum measured value in counts MEAS Opt
MA.MEA Maximum measured value in the unit of the measured value MEAS Opt
MA.TEM Temperature for the maximum measured value in °C MEAS Opt
MA.TIM Time in s until the maximum measured value is reached MEAS Opt
MA.TRN Transmission for maximum measured value in % MEAS Opt
MI.CNT Intensity for minimum measured value in counts MEAS Opt
MI.MEA Minimum measured value in the unit of the measured value MEAS Opt
MI.TEM Temperature with minimum measured value in °C MEAS Opt
MI.TIM Time for the minimum measured value in s MEAS Opt
MI.TRN Transmission for minimum measured value in % MEAS Opt
MTE Temperature measurement with sensor; 1 = on, 0 = off) CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
NMP Number of measuring points in measuring point list CAL MEAS
Opt, CVS,
MEAS Opt,
MEAS Opt
Conc, MEAS
TMF
OUT Number of outliers CAL LOOP Opt
PK{x}.ABS Absorbance of the peak x (1 - 9) in mAU MEAS Spec
PK{x}.TRN Transmission of the peak x (1 - 9) in % MEAS Spec
PK{x}.CNT Intensity of the peak x (1 - 9) in counts MEAS Spec
PK{x}.CNR Intensity of the peak x (1 - 9) in the reference spectrum in counts MEAS Spec
PK{x}.CND Intensity of the peak x (1 - 9) in the dark spectrum in counts MEAS Spec
PK{x}.WVL Wavelength of the peak x (1 - 9) in nm MEAS Spec
PK{x}.SAT Detector with peak x (1 - 9) saturated: 1 = saturated;0 = not saturated MEAS Spec
RPM Stirring rate in min -1 CVS
RAN Current absolute rotation angle of the rack in ° in relation to the axis of the
selected tower (entry when exiting the command) MOVE
RPO Current rack position (entry when exiting the command); 0 means 'not defined' MOVE