Metrohm viva 1.0 Manual - Manual (Page 555)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 543
Type = Number
Input range
-1.0E-99 - 1.0E+99
Type = Text
Entry
max. 100 characters
Type = Date/Time
Selection
'YYYY-MM-DD' or 'YYYY-MM-DD hh:mm:ss'
NOTE
If the sample identifications are still invalid at the start of the method
and are to wait for the REQUEST command before being entered in
the run, then the Check at start option in the START command must
be deactivated for these sample data variables.
Sample type
Sample type.
Selection Sample | Standard
Default value Sample
Sample position
Position of the sample on the sample changer rack. This number can be
used to move to the sample position with a MOVE command when Tar-
get position = Sample position.
Input range 1 - 999
Default value 1
Sample amount
Numerical value for the sample amount for which the standard result is
calculated (see Glossary, page 872).
Entry Number with 10 digits at most
Default value 1.0
Sample amount unit
Unit of the sample amount. Any text can be entered into this field.
Entry 16 characters
Selection L | mL | µL | g | mg | µg | pieces
Default value mL