Metrohm viva 1.0 Manual - Manual (Page 411)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 399
Identification Description
ELT Variable for electrode test:
0 = Electrode test has not been performed
1 = Electrode test has been performed once
2 = Electrode test has been performed twice
3 = Electrode test has been performed three times
FIN Command status: 1 = Command has ended at
least once, 0; invalid (variable not available) =
Command has never ended
HCR Largest current measuring range used:
1 = 224 mA | 2 = 20 mA | 3 = 2 mA | 4 = 200 µA |
5 = 20 µA | 6 = 2 µA | 7 = 200 nA |
8 = 20 nA9 = 2 nA | 10= 200 pA
LCR Lowest current measuring range used:
10 = 200 pA | 9 = 2 nA | 8 = 20n A | 7 = 200 nA |
6 = 2 µA | 5 = 20 µA | 4 = 200 µA | 3 = 2 mA |
2 = 20 mA | 2 = 224 mA
NMP Number of measuring points in measuring point list
RPM Stirring rate in min -1
STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after an error
Result variables if called by CALL VA
The following result variables are generated in the method run when a
CVS command is called by CALL VA and can be used in formulas:
Result variables per substance, variation and replication
Designation 'RS.'Command name'.'Substance
name'.VAR{x}.REP{y}.Variable identification'
Identification Description
SUBST Substance name
POT Peak potential
AREA Peak area
HGT Peak height