Metrohm viva 1.0 Manual User Manual
Page 588
5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
576
￭￭￭￭￭￭￭￭
viva 1.0
Input range
0 - 6
Default value
2
Selection
# | m | µ | n | p
Default value
#
RSD of the heights of all replications
Number of decimal places for the relative standard deviation of the peak
heights of all replications for the variation X (%).
Input range
0 - 6
Default value
1
Area
Number of decimal places and prefix selection for the peak area (C).
Input range
0 - 6
Default value
2
Selection
# | m | µ | n | p
Default value
#
RSD of the areas of all replications
Number of decimal places for the relative standard deviation of the peak
areas of all replications for the variation X (%).
Input range
0 - 6
Default value
1
Start base point
Number of decimal places for the start base point at which the peak eval-
uation baseline begins (V).
Input range
0 - 6
Default value
3
End base point
Number of decimal places for the end base point at which the peak evalu-
ation baseline ends (V).
Input range
0 - 6
Default value
3
Standardized area
Number of decimal places for the standardized peak area.
Only for the DT calibration method! This result is not calculated if the
measuring command is called by a CALL COND!
Input range
0 - 6
Default value
3