Metrohm viva 1.0 Manual - Manual (Page 463)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 451
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this check box is activated, then a maximum of three new measured val-
ues can be adopted from other measuring commands (e.g. MEAS) and
saved that can also be displayed as curves under the designation External
1 - 3 and be used as variables 'Command name.EX1 - 3' in formulas.
[New]
Opens the External measured value # dialog window, in which the
parameters for the external measured value can be entered (see Chapter
5.5.2.5.7.2, page 458).
[Properties]
Opens the External measured value # dialog window, in which the
parameters for the external measured value can be edited (see Chapter
5.5.2.5.7.2, page 458).
[Delete]
Deletes the external measured value selected in the table.
5.5.2.5.6 MEAS TMF
5.5.2.5.6.1 MEAS TMF - Overview
Dialog window: Method ▶ MEAS TMF ▶ Properties... ▶ MEAS TMF - 'Command
name'
Command for the determination of the transmission factor of a
measurement configuration.
Instruments
This command can be executed with the following instrument:
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the MEAS TMF command are set on the following
tabs: