Metrohm viva 1.0 Manual - Manual (Page 336)

4.6 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
324 ￭￭￭￭￭￭￭￭
viva 1.0
Smoothing
on | off (Default value: off)
Activates/deactivates smoothing for the curves.
Smoothing factor x axis
Factor for smoothing in the direction of the x axis.
Input range 0.01 - 1,000
Default value 0.01
Smoothing factor y axis
Factor for smoothing in the direction of the y axis.
Input range 0.01 - 1,000
Default value 0.01
Also show original curve
on | off (Default value: off)
If this check box is activated, then the original curve (solid line, same
color) will be shown in addition to the smoothed curve (dotted line).
4.6.2.3.3 Curve properties MEAS - y2 axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ y2 Axis
Parameters for the graphical display of the overlaid curves on the y2 axis
(right-hand y axis).
Quantity
Selection of the quantity to be shown on the y2 axis.
For MEAS Ref
Selection
Wavelength [nm] | Intensity [Counts] | Inten-
sity Dark [Counts] | Transmission [%] | Satura-
ted pixels | off
Default value off
For MEAS Spec
Selection
Wavelength [nm] | Absorbance [mAU] | Inten-
sity [Counts] | Intensity Dark [Counts] | Inten-
sity Ref [Counts] | Transmission [%] | Satura-
ted pixels | off
Default value off