Metrohm viva 1.0 Manual - Manual (Page 811)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
viva 1.0
￭￭￭￭￭￭￭￭ 799
Solution
Solution
Shows the solution that is assigned to the dosing unit. If no solution is
assigned, ----- is displayed.
8.4.2.3 Dosing - Preparing
Program part: Manual control
Dosing unit preparation can be started and stopped here. This tab appears
both when an individual or all dosing devices are selected.
[Start]
Starts preparation for the selected dosing device(s). In the process, the
parameters defined for the dosing unit will be used.
[Stop]
Stops preparation for the selected dosing device(s).
8.4.2.4 Dosing - Filling
Program part: Manual control
The filling of dosing units can be started and stopped here. This tab
appears both when a single dosing device or all dosing devices are
selected.
[Start]
Starts filling for the selected dosing device(s).
[Stop]
Stops filling for the selected dosing device(s).
8.4.2.5 Dosing - Emptying
Program part: Manual control
Emptying of dosing units can be started and stopped here. This tab
appears both when a single dosing device or all dosing devices with dos-
ing units are selected.
[Start]
Starts emptying for the selected dosing device(s). In the process, the
parameters defined for the dosing units will be used.
[Stop]
Stops emptying for the selected dosing device(s).