Metrohm viva 1.0 Manual - Manual (Page 406)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
394 ￭￭￭￭￭￭￭￭
viva 1.0
Command variables
The following command variables are generated by the EXIT command in
the method run and can be used in formulas under the designation 'Com-
mand name.Variable identification':
Identifi-
cation Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
5.5.2.2.8 ERROR
Dialog window: Method ▶ ERROR ▶ Properties... ▶ ERROR - 'Command name'
Start command for the error track.
Appearance
The command has the following appearance:
Parameters
Command name
Name of the command.
Entry 1 - 25 characters
Default value Error track
Live display
on | off (Default value: on)
If this check box is activated, then the track will be displayed in the live
display.
Command variables
The following command variables are generated by the ERROR command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':