Metrohm viva 1.0 Manual - Manual (Page 469)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 457
Temperature
Temperature
Measuring temperature which can be entered manually. The temperature
is measured continuously when Temperature measurement = contin-
uous (tab General/Hardware).
Input range 20.0 - 60 °C
Default value 25.0 °C
5.5.2.5.7 Additional measured values
5.5.2.5.7.1 Calculated measured value
Dialog window: Method ▶ MEAS ▶ Properties... ▶ Additional measured val-
ues ▶ [New]/[Properties] ▶ Calculated measured value
With the Additional calculated measured values option, a maximum
of three new measured values can be calculated and saved from existing
measured values that can also be displayed as curves under the designa-
tion Calculated 1 - 3 and be used as variables *.CA1 - 3 in formulas.
Name
Designation of the calculated measured value. This name is used for the
axis labeling.
Entry 25 characters
Default value Calculated measured value #
Formula
Calculation formula for the calculated measured value that can be created
with the formula editor after pressing .
Entry 1,000 characters
Default value 'empty'
Unit
Unit of the calculated measured value.
Selection 'empty' | ppm | % | g/L | mg/L | mg/mL | mg/
100 g | mol/L | mmol/L | mL | g | mg | µg | °C |
µL | s | mS/cm
Default value 'empty'
Digits
Number of decimal places with which the calculated measured value is to
be displayed.