Metrohm viva 1.0 Manual - Manual (Page 510)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
498 ￭￭￭￭￭￭￭￭
viva 1.0
Appearance
The command has the following appearance:
Parameters
The parameters for the RLS DOS command are configured in the follow-
ing dialog window:
￭ RLS DOS - Properties
Command variables
The following command variables are generated by the RLS DOS com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
5.5.2.7.9.2 RLS DOS - Properties
Dialog window: Method ▶ RLS DOS ▶ Properties... ▶ RLS DOS - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.